“Today’s article is about how to fix netgear router blinking orange , if you have flashing orange light on your wifi router. please follow the steps given into this article.”
People, who are honored with Netgear Wireless router, feel very happy with its execution.
However, at some point it makes a truly basic issue for clients such as Netgear router is blinking orange, one of the most serious issue nowadays.
So today in this article, we will talk about what is the reason for this problem and how to troubleshoot Netgear router is blinking orange.
you need to read this article properly and follow the instructions to fix your router problem by yourself.
Why is my Netgear router blinking orange :
Well, there are few reasons for Netgear router blinking orange. which is listed below:
- Internet service provider (ISP) Problem.
- Connection problem.
- DNS/ DHCP Problem.
- Using a Router with old firmware.
How to fix Netgear router is blinking orange Issue:
So we have already discussed the causes of why my Netgear router is blinking orange. now it’s a time to troubleshoot such a problem. Let’s go with the instructions below.
Internet service provider (ISP) Problem – before you will go for any further alternatives, first you have to ensure that you are getting the internet from ISP.
So you need to connect your modem directly to the computer via Ethernet cable and try to access the internet.
Check Connection – you should make sure, which connection type, do you have?
Some ISP provides PPOE or static ip connection, so if you have such connection type. You have to set up your router manually by entering the internet information.
Connection Problem – at some point, you may have “Netgear router is blinking orange ” due to the wrong connection between router and modem.
So you have to ensure that your modem is appropriately connected from internet port to the router. Once your router will be connected to the modem. you have to reboot your router and wait for one minute.
once your router will be connected to the modem. you have to reboot your router and wait for one minute.
When you will make the proper connection between the Netgear router and modem. you have to reboot your router and wait for one minute.
Mac cloning – At the point when your modem is not ready to recognize Netgear router. We have to do mac cloning. so your modem can serve the internet to your router. for mac cloning you need to follow the instructions below:
- Open Netgear router setup page.
- Go to advance option.
- Now mac cloning.
- Finally, you need to click on the clone and click on apply.
Using Router With Old Firmware-
if you are using an old Netgear router. it may cause Netgear router blinking orange issue as a result of old firmware.
Factory Restore- if you have tried all methods listed in above paragraphs. But still, your Netgear router is blinking orange.
In such a situation, you need to restore your router. so you need press and hold the factory restore button for 30 seconds and release the button.
Once you will reset your router successfully then you need to setup Netgear router once again. For more information you may visit: How To Setup Netgear Router?
After following all these instructions, I am sure your Netgear router will start working fine. but somehow, if your Netgear router is still blinking orange. in such a situation, your router might be a hardware failure. so you need to replace your router.
in such a situation, your router might be a hardware failure. so you need to replace your router.
you may also read:
If you have any other issue with your Netgear router or any other electronic gadget, please leave a comment below.
we will share troubleshooting steps in our next post for that specific post.
if you have any query, just visit: